Polystyrene Bead Molding Introduction On September 7th and 14th of 2000 my research testing ground partners and I conducted the polystyrene astragal fakeing project. My research research laboratory partners are Josh Dick, Mike Ward, and Keith Matlock, and we conducted the routine in room W126 of the Kansas Technology Center. We were to attempt to make polystyrene bead molds using devil different methods. In theory we would be able to set the bead edge. Theory Polystyrene bead molding can be performed in two manners. One sort is to charter the mold 25 to 30 percent right and so applying heat, all rileing water or cook it. Another way is to boil the raw beads, dry the beads, fill the mold with them, and then heat it in an oven. We were to attempt some(prenominal) of these procedures in our lab project. My expectations were that the molds would turn out good.
Materials & Equipment Locations water container to boil water lab electric stove lab oven lab aluminum molds lab pan container to ...If you want to get a full essay, smart set it on our website:
OrderCustomPaper.comIf you want to get a full essay, visit our page:
write my paper
No comments:
Post a Comment